+- (https://6mmarc.com)
+-- Forum: 6MMARC DISCUSSION (https://6mmarc.com/forumdisplay.php?fid=3)
+--- Forum: 6mmARC Build Help & Troubleshooting (https://6mmarc.com/forumdisplay.php?fid=10)
+--- Thread: Howa mini scope rings (/showthread.php?tid=1387)
Howa mini scope rings - DeadEyeSly - 09-10-2024
I am looking at Talley lightweight low rings for a Howa mini. Scope will be a 1" tube with 40-42mm objective. Not sure if the low rings will work. Also if you are using these rings did you go with the standard or extended rings?
RE: Howa mini scope rings - DeadEyeSly - 09-26-2024
I ended up going with the Talley standard low rings. Both my leupold 3-9x40 and burris 4.5-14x42 fit just fine. I was concerned that the bolt handle would hit the eye piece power adjustment ring. It is close but not an issue. Hopefully this info helps someone in the future.
RE: Howa mini scope rings - Rickhem - 10-03-2024
Good deal on following up with the solution. Much appreciated.
I also went with Talley rings on mine, and plenty of clearance with both scopes that I've had in them. One was a Nikon Slughunter 3-9x40, and the other was a Vortek Diamondback 4-16x42.