07-26-2020, 03:04 PM
I ended up removing the 20 MOA scope riser, I don't think it is needed inside of 1000 yards. If I can get to the long range I can give it a try without. If the sight picture does not look right because I am at the edge of the glass then I will try it. If thats the case I will get a 20 MOA mount to try and keep the glass as close to the bore center line as possible, not that this is uber important but it does help a little, and it looks better as well.
I barely had to make any adjustment to the scope out of the box setting, the windage was right on, and the elevation only took 6 clicks to set it at the bottom of the 10 ring. two shots and I was printing inside the 10 ring every shot holding at the top of the ring @ 100 yards.
I barely had to make any adjustment to the scope out of the box setting, the windage was right on, and the elevation only took 6 clicks to set it at the bottom of the 10 ring. two shots and I was printing inside the 10 ring every shot holding at the top of the ring @ 100 yards.