06-28-2021, 02:24 AM
After shooting factory ammo and reloaded ammo in this Savage Axis I am sorry to report what I would describe as a firing pin issue. The reloaded ammo has been primed with CCI 450's if that matters.
The issue experienced is the primer is protruding in to the clearance for the firing pin hole is the best description I can come up with. This presents an issue when going to deprive the cases. The case does not fit in the shell holder without pressing in the primer or releaving the shell holder with a grinder to provide clearance where the primer protrusion is causing interference.
Anyone have an idea for a solution for the protruding primer in to the firing pin clearance in the bolt?
The issue experienced is the primer is protruding in to the clearance for the firing pin hole is the best description I can come up with. This presents an issue when going to deprive the cases. The case does not fit in the shell holder without pressing in the primer or releaving the shell holder with a grinder to provide clearance where the primer protrusion is causing interference.
Anyone have an idea for a solution for the protruding primer in to the firing pin clearance in the bolt?