Need Help with Hornady Full Length Die
#7
(07-20-2021, 11:05 PM)StoneHendge Wrote: A 6.5 Grendel body will have the shoulder 0.03" higher but maybe it's possible to screw it down that far. Do you have have any Grendel brass you could run through it?
Unfortunately, no.  I don't shoot 65 Grendel

(07-21-2021, 02:30 AM)CZ527 Guy Wrote: I doubt you could bump the shoulder w a 6. 5 grendel die as the die should hit your shell holder prior to touching the shoulder. How is it that you are sure you had bumped the shoulder?

Look forward to what answer Hornady has for you. Sounds like this is going to be stretched out longer than I anticipated.

BTW Whidden is another option not inexpensive though an option. may be more than you were wishing for. I purchased my first & only Whidden die in 6mm Arc and will say I am pleased. also purchased there shoulder bump gauge & am very happy w all products thus far.

https://www.whiddengunworks.com/product/...ing-kit-2/
I measured some fired cases with the Hornady comparator as a reference. 

Those Whidden dies look nice.  I might have to buy those even if Hornady figures something out.  If I had known about Whidden I probably would have purchased them in the first place.

Thanks for the tip.
Reply


Messages In This Thread
Need Help with Hornady Full Length Die - by gkf - 07-20-2021, 05:48 PM
RE: Need Help with Hornady Full Length Die - by gkf - 07-21-2021, 03:19 AM

Forum Jump:


Users browsing this thread: 14 Guest(s)