10-04-2021, 08:59 AM
(This post was last modified: 10-04-2021, 09:04 AM by r.tenorio671.
Edit Reason: add clarity
)
....I have one and I'm thoroughly satisfied with it. I do my 300BLK, 556, 308 and now 6ARC on it with excellent results. I know some folks would prefer it had a chute feeder, but I didn't feel it was too slow to hand feed it, especially since it took less than 10 seconds max to cycle thru any of the cases. I was able to go thru a full coffee cannister of cases in no time and the ease of adjusting the depth for case length only takes seconds. 200 cases done in less than a half hour.
What surprised me the most was just how compact it is, great for folks without a bench or alot of room to work on, heck, it can even be done sitting at the dining table. Maybe one day when I'm bored I'll devise some kind of chute feeder, but not really necessary IMHO. Here's a sample of my converted 6.5G brass that was annealed before resizing. These were straight from the bag to annealing, those dark spots on the shoulder of left case is probably from the lubricant Starline puts on their cases before packaging. The cases shown are my test cases for setting up the seating die for the Nosler 70gn VG and 105 RDF.
What surprised me the most was just how compact it is, great for folks without a bench or alot of room to work on, heck, it can even be done sitting at the dining table. Maybe one day when I'm bored I'll devise some kind of chute feeder, but not really necessary IMHO. Here's a sample of my converted 6.5G brass that was annealed before resizing. These were straight from the bag to annealing, those dark spots on the shoulder of left case is probably from the lubricant Starline puts on their cases before packaging. The cases shown are my test cases for setting up the seating die for the Nosler 70gn VG and 105 RDF.