11-15-2021, 10:02 PM
(This post was last modified: 11-15-2021, 10:48 PM by Thelaststraw.)
I use a 550 but I would suggest not using a powder drop in a progressive setup. Grendel shell plate and a sizing die in 1st stage, 0.241 Mandel in second, and micrometer seater in third stage of a whidden floating toolhead. I decap separately and then clean, trim, etc.
I would suggest using a separate drop or an automated dropper if you feel spendy. It's not that it's bad but it depends on your expectations for ammo consistency. Most ball powders will meter well, but +/- 0.1-0.2 grains may or may not meet your needs. I always trickle within 0.1 gr for my needs.
Figured I should add....if you are just looking for a decent load to shoot cans and casually punch steel I imagine the dropper would meter plenty good for your needs( powder depending). Try calling or email Dillon, their CS is top not h and I bet they know which drop tube fits 6ARC. Sorry for the tangents.
I would suggest using a separate drop or an automated dropper if you feel spendy. It's not that it's bad but it depends on your expectations for ammo consistency. Most ball powders will meter well, but +/- 0.1-0.2 grains may or may not meet your needs. I always trickle within 0.1 gr for my needs.
Figured I should add....if you are just looking for a decent load to shoot cans and casually punch steel I imagine the dropper would meter plenty good for your needs( powder depending). Try calling or email Dillon, their CS is top not h and I bet they know which drop tube fits 6ARC. Sorry for the tangents.