Dillon presses and 6mm ARC

[SwissyJim]

I use a 550 but I would suggest not using a powder drop in a progressive setup. Grendel shell plate and a sizing die in 1st stage, 0.241 Mandel in second, and micrometer seater in third stage of a whidden floating toolhead. I decap separately and then clean, trim, etc.

I would suggest using a separate drop or an automated dropper if you feel spendy. It's not that it's bad but it depends on your expectations for ammo consistency. Most ball powders will meter well, but +/- 0.1-0.2 grains may or may not meet your needs. I always trickle within 0.1 gr for my needs.

Figured I should add....if you are just looking for a decent load to shoot cans and casually punch steel I imagine the dropper would meter plenty good for your needs( powder depending).  Try calling or email Dillon, their CS is top not h and I bet they know which drop tube fits 6ARC. Sorry for the tangents.

I hear you on the powder stuff... I do my 6.5cm load with a powder thru die and hand measure each load. Not a plinker so easy enough to do. I'll do the same for the ARC..
I'm curious if you use commercial brass, or formed Grendel brass. I did talk to Dillon, and the tech told me the Grendel shellplate and pins with a 6ppc drop would work, but ONLY with Grendel formed brass. Commercial ARC brass had issues with that and they were close to having a new shellplate specific to 6mm ARC original brass.

---

I made a powder funnel from a 7.62x39 one that came with my 6ppc adapter kit.  The 6ppc one did not work for 6mm ARC (this is for xl 650).  I used a 6 ARC case with release agent and epoxy in the 7.62x39 funnel. It works o.k. I mostly use a single stage for the ARC so I can weigh every charge.  If I find the magic load then I'll try some out with the Dillon.

Interesting... The Dillon tech I talked to said the 6ppc funnel would work. Be interesting to see when their caliber conversion comes out. They have them listed as backorderable on their site. Was told 6-8 weeks. I'll prob do the same I do with my 6.5cm load and hand weigh each anyways. Do you resize your brass, or use original ARC brass?