I just got my Faxon barrels, the 20" came yesterday and the 18" today along with another 200 rounds of 108's that I ordered from GA Precision a couple of days ago, that was fast shipping.
Tomorrow I am going to get the tools out and measure the chambers on all three of my barrels and compare them. I have to go to Kromehard. It's a tool store that specializes in drill bits, machinist tools, taps and dies, ect... I need a 5/16 36 tap so I can make a 6 Arc modified case, as non are available.
My range trip today was pretty good as far as accuracy, all 100 yard targets were well below MOA, I have not measured them yet but was putting holes inside of holes. One target that I put 20 rounds into the whole center of the target inside of an MOA was gone. Ringing steel at 600 with ease.
I figured out my lock back issue, and short stroking, it was the adjustment on the gas block, all is good now with those issues.
I'll report back with what I find out about chamber dimensions. I needed a fired case to make the tool with.
Tomorrow I am going to get the tools out and measure the chambers on all three of my barrels and compare them. I have to go to Kromehard. It's a tool store that specializes in drill bits, machinist tools, taps and dies, ect... I need a 5/16 36 tap so I can make a 6 Arc modified case, as non are available.
My range trip today was pretty good as far as accuracy, all 100 yard targets were well below MOA, I have not measured them yet but was putting holes inside of holes. One target that I put 20 rounds into the whole center of the target inside of an MOA was gone. Ringing steel at 600 with ease.
I figured out my lock back issue, and short stroking, it was the adjustment on the gas block, all is good now with those issues.
I'll report back with what I find out about chamber dimensions. I needed a fired case to make the tool with.