Rebarrel a cz527
#16
Did look at Boyds current offerings, Looks like they offer at least 3 stocks with the adjustable LOP. Suppose see if any of these suit your needs or taste.

BTW My experience with CZ527 in 6.5 Grendel. Worked with some heavier loads recoil did result in some splintering or failure in the rear of the aaction frame. Thus Id recommend not following my example in not bedding the action. Even though the 6mm ARC likely will have considerably less recoil than my 6.5 G reloads were subjecting the stock to.

You have roughly 6 months to look in to this. You may do well to glass Bed at least the lug of not the entire action. Just a consideration.

Bell & carlson offers another of my favorite consideration if you are not needing the adjustable LOP. Aluminum bedding block has a real plus IMHO.

http://www.bellandcarlson.com/index.cfm?...ry_ID=1096
Reply


Messages In This Thread
Rebarrel a cz527 - by Bassfish1952 - 05-23-2022, 12:45 PM
RE: Rebarrel a cz527 - by grayfox - 05-23-2022, 06:18 PM
RE: Rebarrel a cz527 - by Bassfish1952 - 05-23-2022, 07:06 PM
RE: Rebarrel a cz527 - by CZ527 Guy - 05-23-2022, 10:10 PM
RE: Rebarrel a cz527 - by Bassfish1952 - 05-24-2022, 01:17 PM
RE: Rebarrel a cz527 - by CZ527 Guy - 05-23-2022, 10:22 PM
RE: Rebarrel a cz527 - by MTMAN - 05-24-2022, 04:38 PM
RE: Rebarrel a cz527 - by Bassfish1952 - 05-24-2022, 05:23 PM
RE: Rebarrel a cz527 - by CZ527 Guy - 05-25-2022, 09:29 PM
RE: Rebarrel a cz527 - by Bassfish1952 - 05-26-2022, 12:32 PM
RE: Rebarrel a cz527 - by MTMAN - 05-27-2022, 12:25 AM
RE: Rebarrel a cz527 - by CZ527 Guy - 05-27-2022, 02:35 AM
RE: Rebarrel a cz527 - by Bassfish1952 - 05-30-2022, 01:23 PM
RE: Rebarrel a cz527 - by CZ527 Guy - 05-30-2022, 07:35 PM
RE: Rebarrel a cz527 - by Bassfish1952 - 05-31-2022, 09:35 PM
RE: Rebarrel a cz527 - by CZ527 Guy - 06-01-2022, 12:53 AM
RE: Rebarrel a cz527 - by Bassfish1952 - 06-02-2022, 01:07 PM
RE: Rebarrel a cz527 - by grayfox - 06-02-2022, 03:32 PM
RE: Rebarrel a cz527 - by Bassfish1952 - 06-02-2022, 06:22 PM

Forum Jump:


Users browsing this thread: 16 Guest(s)