Id like to think you may find someone getting out of reloading where you might acquire everything you need including the reloading bench except your dies. ( unlikely the party would have 6mm ARC Dies) These days Id feel hard pressed to get the bare minimum in reloading equipment for less than $1,200.00 when you include the following.
Bench
Press
die set
trimmer
scale
powder thrower
caliper
primer seating tool for small rifle primers
Reloading manual
chamfer tool
shell tray
funnel ? Drop tube
Id do some searching for a press in any of a number of brand names including RCBS, Redding or Hornady. I am partial towards the RCBS priming tool. As for powder throwers Id seriously consider any of a number of throwers out there meant for smaller charges.
Lynman, Hornady, Redding & RCBS powder throwers would be on my list. then you are looking for a scale for weighing your powder an old beam scale followed by a digital scale would be on my list.
A quality newer digital 6" caliper is a tool Id not wish to do without. This is to check seating depth & Trim length. If I was only going to reload 6mm ARC the WFT trimmer is the trimmer for 6.5 grendel is the only consideration I would recommend. https://www.midwayusa.com/product/101285306
If you get serious we could go into deeper recommendations. Johnny reloading bench youtube videos may be an ok place to start off with to get a glimpse of an idea of what you could be getting into.
https://video.search.yahoo.com/search/vi...tion=click
https://www.youtube.com/watch?v=mOd-Sj_Eh5A
Bench
Press
die set
trimmer
scale
powder thrower
caliper
primer seating tool for small rifle primers
Reloading manual
chamfer tool
shell tray
funnel ? Drop tube
Id do some searching for a press in any of a number of brand names including RCBS, Redding or Hornady. I am partial towards the RCBS priming tool. As for powder throwers Id seriously consider any of a number of throwers out there meant for smaller charges.
Lynman, Hornady, Redding & RCBS powder throwers would be on my list. then you are looking for a scale for weighing your powder an old beam scale followed by a digital scale would be on my list.
A quality newer digital 6" caliper is a tool Id not wish to do without. This is to check seating depth & Trim length. If I was only going to reload 6mm ARC the WFT trimmer is the trimmer for 6.5 grendel is the only consideration I would recommend. https://www.midwayusa.com/product/101285306
If you get serious we could go into deeper recommendations. Johnny reloading bench youtube videos may be an ok place to start off with to get a glimpse of an idea of what you could be getting into.
https://video.search.yahoo.com/search/vi...tion=click
https://www.youtube.com/watch?v=mOd-Sj_Eh5A