08-19-2022, 04:55 PM
(This post was last modified: 08-19-2022, 05:00 PM by Panshovevo.)
Thanks Bob. I’ll look in to it further today, and post what I find.
If the max/min dimension refers to the extractor groove size, the small side of the standard jaws might work.
I loaded 223 and 308 years ago on a friend’s Coax press, with very good results. I should have bought one back then when they sold for around $200. I got this one from Brownells recently for $365, which was well below other advertised prices I had seen when almost no one had them in stock.
If the max/min dimension refers to the extractor groove size, the small side of the standard jaws might work.
I loaded 223 and 308 years ago on a friend’s Coax press, with very good results. I should have bought one back then when they sold for around $200. I got this one from Brownells recently for $365, which was well below other advertised prices I had seen when almost no one had them in stock.