6.5 grendel to 6mm arc
#5
Boy my experience with recently purchased Starline brass seems to have been considerably better. Order was for 250 cases & i think I received 2 extra. weight variation was within 1.5 grains. never annealed prior to first firing. Used what may be considered a premium forming die. (mighty armory) with lanolin based spray on lube. Brass forms considerably easier than I have experienced in the past.

BTW past experience has been quite easy any way. I have been a huge fan of imperial sizing wax in the past. Though with this Mighty armory die the PEG 75 (lanolin based lube) worked amazingly smooth. inadvertianly I did run a few with my tried & true Whidden form die. Don't get me wrong. The Whidden die is a top of the line die. Mighty armory is just that much better IMHO.

With either of my dies I have never come remotely close to sticking a case. Ill atribute this to this success to good lube adiquitly applied. Good smooth dies with a 5 micro or better polished ID docent hurt either. I have had very good luck with both Starline & Lapua 6.5 Grendel brass. Though to be fair I have quite a bit of history re-forming brass to alternate calibers. So I went through my learning curve on 17 fireball & 17 Hornady Hornet.
Reply


Messages In This Thread
6.5 grendel to 6mm arc - by herman lesley - 09-15-2022, 12:00 PM
RE: 6.5 grendel to 6mm arc - by BG Shooter - 09-15-2022, 01:13 PM
RE: 6.5 grendel to 6mm arc - by alwie - 09-15-2022, 03:37 PM
RE: 6.5 grendel to 6mm arc - by GRH - 09-16-2022, 01:12 PM
RE: 6.5 grendel to 6mm arc - by CZ527 Guy - 09-16-2022, 03:59 PM
RE: 6.5 grendel to 6mm arc - by GRH - 09-16-2022, 08:52 PM
RE: 6.5 grendel to 6mm arc - by StoneHendge - 09-17-2022, 12:29 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)