09-18-2022, 11:53 PM
(09-18-2022, 10:55 PM)Ordsgt Wrote: DinoAnneal your brass before you size, it is taking to much pressure to size it and it is buckeling at the weak point at the bottom of the brass. Lapua brass in this load is pure crap. or you are over pressure.
Powder is weighed on electronic dispense and checked with beam scale
CZ527
Load is well below max and velocity and primer do not show pressure. The fired cases are good no visible signs of any problem. The damage occurs during the sizing operation,but not with hornady brass or new unfired lupua reformed. The rifle is an AR and the dies are RCBS small base. The shoulder is pushed back .003
https://www.65grendel.com/forum/showthre...seperation
If you can not see the tyranny of having a gun ban enforced by men with guns... Then you fail to understand why the second amendment was written in the first place.