11-19-2022, 06:17 PM
I have a a Forster Accu-Ring Cross Bolt Die Lock Ring that has .001 graduation . Sweet. Shoulder bump is where i want it to be.
I have no problem cycling reloaded ammo. My concern is over-working the body @.006 reduction of body diameter after sizing. This leaves a noticeable ring about .200" from base. I just checked my 223 to compare. It resizes the body by about .002 to 0025" with no noticeable ring.
So, shoulder bump not a problem and reloads not a problem. Just wondering if .006 is too much overworking the body, which will lead to shorter case life.
Waiting on response from L E Wilson.
I appreciate your response.
Cheers
Philip
I have no problem cycling reloaded ammo. My concern is over-working the body @.006 reduction of body diameter after sizing. This leaves a noticeable ring about .200" from base. I just checked my 223 to compare. It resizes the body by about .002 to 0025" with no noticeable ring.
So, shoulder bump not a problem and reloads not a problem. Just wondering if .006 is too much overworking the body, which will lead to shorter case life.
Waiting on response from L E Wilson.
I appreciate your response.
Cheers
Philip