01-05-2023, 12:02 AM
(01-04-2023, 03:13 PM)aknott1994 Wrote: I ran a couple cases through my 6.5 Grendel die and then necked them back down with no change in results as well. I did find out that the Hornady 105 bthp touch the lands at 2.250 using the Hornady tool. Could it be the dies that I am using? It's an ATI Omni gas gun and I am using the Lee Pacesetter die set. I use these dies for other cartridges but heard 6 ARC can be picky
Where are you located? Sounding more like yes, your dies may be the issue. If you would like to mail me a fired case & a resized case Id measure the shoulder datum point on both to verify difference.
Am I reading to much into this? Were these factory rounds that were fired in your rifle, then resized? Meaning factory ammo chambers fine? Have you tried chambering a resized case only that has not been reloaded?