|
Reloading Issues
|
01-07-2023, 09:11 PM
I bought some new gauges today and my dies are re-sizing back to exactly 1.190 to the datum line and factory brass is measuring 1.183-1.184. At 1.190 my cases fit in the case checker just fine. I'm guessing my chaber is a little short and I need new dies that will bump it back a little further. While I was out I also picked up some CFE223 so I may or may not abandon the IMR 3031 and use that in my 5.56
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Reloading Issues - by aknott1994 - 01-04-2023, 03:22 AM
RE: Reloading Issues - by alwie - 01-04-2023, 04:20 AM
RE: Reloading Issues - by grayfox - 01-04-2023, 06:46 AM
RE: Reloading Issues - by CZ527 Guy - 01-04-2023, 10:33 AM
RE: Reloading Issues - by aknott1994 - 01-04-2023, 01:02 PM
RE: Reloading Issues - by aknott1994 - 01-04-2023, 03:13 PM
RE: Reloading Issues - by CZ527 Guy - 01-05-2023, 12:02 AM
RE: Reloading Issues - by aknott1994 - 01-05-2023, 06:20 PM
RE: Reloading Issues - by grayfox - 01-04-2023, 05:01 PM
RE: Reloading Issues - by Dino11 - 01-05-2023, 11:41 AM
RE: Reloading Issues - by CZ527 Guy - 01-05-2023, 10:59 PM
RE: Reloading Issues - by aknott1994 - 01-07-2023, 09:11 PM
RE: Reloading Issues - by CZ527 Guy - 01-07-2023, 11:18 PM
RE: Reloading Issues - by aknott1994 - 01-08-2023, 01:11 AM
RE: Reloading Issues - by GRH - 01-12-2023, 02:01 PM
RE: Reloading Issues - by CZ527 Guy - 01-07-2023, 11:38 PM
RE: Reloading Issues - by CZ527 Guy - 01-08-2023, 02:17 AM
RE: Reloading Issues - by aknott1994 - 01-08-2023, 02:37 AM
|
