|
Reloading Issues
|
01-07-2023, 11:38 PM
In my honest opinion Lee should make this right. If not a guy could have a machinist remove .oo45" from the face of the die to allow the shoulder to be pushed back further. Not sure if the redding shell holder set would benefit your situation or not.
https://www.midwayusa.com/product/1012465352?pid=344665 |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Reloading Issues - by aknott1994 - 01-04-2023, 03:22 AM
RE: Reloading Issues - by alwie - 01-04-2023, 04:20 AM
RE: Reloading Issues - by grayfox - 01-04-2023, 06:46 AM
RE: Reloading Issues - by CZ527 Guy - 01-04-2023, 10:33 AM
RE: Reloading Issues - by aknott1994 - 01-04-2023, 01:02 PM
RE: Reloading Issues - by aknott1994 - 01-04-2023, 03:13 PM
RE: Reloading Issues - by CZ527 Guy - 01-05-2023, 12:02 AM
RE: Reloading Issues - by aknott1994 - 01-05-2023, 06:20 PM
RE: Reloading Issues - by grayfox - 01-04-2023, 05:01 PM
RE: Reloading Issues - by Dino11 - 01-05-2023, 11:41 AM
RE: Reloading Issues - by CZ527 Guy - 01-05-2023, 10:59 PM
RE: Reloading Issues - by aknott1994 - 01-07-2023, 09:11 PM
RE: Reloading Issues - by CZ527 Guy - 01-07-2023, 11:18 PM
RE: Reloading Issues - by aknott1994 - 01-08-2023, 01:11 AM
RE: Reloading Issues - by GRH - 01-12-2023, 02:01 PM
RE: Reloading Issues - by CZ527 Guy - 01-07-2023, 11:38 PM
RE: Reloading Issues - by CZ527 Guy - 01-08-2023, 02:17 AM
RE: Reloading Issues - by aknott1994 - 01-08-2023, 02:37 AM
|
