Gents, I hope this is helpful to some of you. I found it to provide the answers that I needed, but I'm also pretty new to this environment.
I asked Starline for guidance on using their Basic Grendel Brass to be form 6mm ARC. My follow-up question was answered. The included file is attached.
Mark,
Here is a great article on annealing. I would suggest trying to only go a 1/4"-3/8" below where the shoulder will be when annealing for 6mm ARC. The ARC has very little body taper so it doesn't need too much below the shoulder.
Regards,
Hunter Pilant
Process Manager
Chief Ballistician
hunter@starlinebrass.com
Starline Inc.
1300 W. Henry Street
Sedalia, MO 65301
800-280-6660
660-827-6640
www.facebook.com/StarlineBrass
I asked Starline for guidance on using their Basic Grendel Brass to be form 6mm ARC. My follow-up question was answered. The included file is attached.
Mark,
Here is a great article on annealing. I would suggest trying to only go a 1/4"-3/8" below where the shoulder will be when annealing for 6mm ARC. The ARC has very little body taper so it doesn't need too much below the shoulder.
Regards,
Hunter Pilant
Process Manager
Chief Ballistician
hunter@starlinebrass.com
Starline Inc.
1300 W. Henry Street
Sedalia, MO 65301
800-280-6660
660-827-6640
www.facebook.com/StarlineBrass
“Draw me not without reason, sheath me not without honor.”