05-11-2023, 12:12 PM
(This post was last modified: 05-11-2023, 12:13 PM by Bassfish1952.)
Directions on the Lee press said
While holding handle against the stop , screw the die in until it touches the shell holder, then release pressure and screw the die in an additional 1//4 to 1/2 turn.
I did that and set at a little between 1/4 and 1/2.
I thought that meant there was no adjustment and have been beating my head against the wall thinking metal to metal meant maxed out.
As soon as I get my first stuck case out I will screw it in to the full half turn point and see what happens. I guess dealing with a few thousands can mean there is a little more give in what I thought was metal to metal.
Thanks
While holding handle against the stop , screw the die in until it touches the shell holder, then release pressure and screw the die in an additional 1//4 to 1/2 turn.
I did that and set at a little between 1/4 and 1/2.
I thought that meant there was no adjustment and have been beating my head against the wall thinking metal to metal meant maxed out.
As soon as I get my first stuck case out I will screw it in to the full half turn point and see what happens. I guess dealing with a few thousands can mean there is a little more give in what I thought was metal to metal.
Thanks