The way to get rid of the belt is to grind 0.020/0.025 off the face of the shell holder. This will allow the case to go deep enough in the die to not leave the belt.
|
Arc problems AGAIN!!!
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Arc problems AGAIN!!! - by rsbhunter - 07-27-2021, 02:18 AM
RE: Arc problems AGAIN!!! - by Dino11 - 07-27-2021, 09:09 AM
RE: Arc problems AGAIN!!! - by LaMan - 07-27-2021, 01:33 PM
RE: Arc problems AGAIN!!! - by rsbhunter - 07-27-2021, 05:46 PM
RE: Arc problems AGAIN!!! - by StoneHendge - 07-27-2021, 06:41 PM
RE: Arc problems AGAIN!!! - by rsbhunter - 07-27-2021, 09:08 PM
RE: Arc problems AGAIN!!! - by Lemonaid - 07-30-2021, 04:15 AM
RE: Arc problems AGAIN!!! - by Dino11 - 07-30-2021, 09:01 AM
RE: Arc problems AGAIN!!! - by rsbhunter - 08-04-2021, 03:57 AM
RE: Arc problems AGAIN!!! - by KenC - 08-15-2021, 01:12 PM
RE: Arc problems AGAIN!!! - by Bologna - 08-15-2021, 09:34 PM
RE: Arc problems AGAIN!!! - by Thelaststraw - 08-16-2021, 10:04 AM
RE: Arc problems AGAIN!!! - by johnnyw - 05-11-2023, 02:27 PM
RE: Arc problems AGAIN!!! - by Dino11 - 05-16-2023, 11:17 PM
RE: Arc problems AGAIN!!! - by BluntForceTrauma - 06-05-2023, 09:06 PM
RE: Arc problems AGAIN!!! - by Cwlongshot - 02-21-2024, 02:18 PM
|
Users browsing this thread: 5 Guest(s)