05-12-2023, 12:31 AM
Have you shot any factory ammo? Did you check the shoulder length of fired brass? Are you using the #350 comparator adapter? Is your bolt closing easy now? It's not a good idea to run tight brass, it can gall your bolt. If your bottomed out with your die adjustment and still tight you might need to anneal the brass.
Personally I would start a little further off the lands, .010" But you should be fine if your not near max charge weight.
That's my 2 cents.
Personally I would start a little further off the lands, .010" But you should be fine if your not near max charge weight.
That's my 2 cents.