06-04-2023, 08:55 PM
Think I just ruined 20 cases & feel fortunate that I discovered the issue before more cases were damaged. After resizing the 20 cases the primers were very difficult to seat full depth, or would not seat full depth. Went to uniform the bottom of the primer pocket & noticed the bottom of the primer pocket less belled out.
First thought is over pressure though primers are fitting nice & tight. Well I did not think the mighty armory die had any adjustment. Took the die apart & never noticed a issue. Took out the stem again & then I noticed the primer ejector pin was threaded out over two turns. threaded it back in all the way & protruded primer pockets cleared up.
Just Hope this may help prevent issues for others.
First thought is over pressure though primers are fitting nice & tight. Well I did not think the mighty armory die had any adjustment. Took the die apart & never noticed a issue. Took out the stem again & then I noticed the primer ejector pin was threaded out over two turns. threaded it back in all the way & protruded primer pockets cleared up.
Just Hope this may help prevent issues for others.