12-19-2023, 07:59 PM
(This post was last modified: 12-19-2023, 08:00 PM by Diesel Pro.)
Anybody know of any body dies being made? I pushed my shoulders back (Hornady 1x fired from factory ammo) what should be .004" but I'm not getting the bolt to lockdown in my Cobalt/Proof setup and to pull the round back out with the charging handle takes a ton of effort. I'm also looking at OAL to ogive set with the comparator. When I push the bullet in super gentle I get one reading, but add a slight bit of pressure it pushes significantly deeper until it hits a solid stop like I am used to feeling.
I do have also have a new CMMG upper that I plan to the loads that are giving grief in, but to me it seems I need to push the shoulder back further.
I also do have some new Starline brass so I can start over, but I hate to knock the loaded ammo apart if I can avoid it.
I do have also have a new CMMG upper that I plan to the loads that are giving grief in, but to me it seems I need to push the shoulder back further.
I also do have some new Starline brass so I can start over, but I hate to knock the loaded ammo apart if I can avoid it.