12-21-2023, 07:02 PM
I think we are compressed at the point that I took this picture which is when I went to push them back a bit deeper The ring was there only less pronounced from initial loading. I loaded a bunch of new brass with my 243 stem and have had no issues and very consistent feel in the stroke of the press. The Hornady brass does seem a bit snug.
I don't have any ELD's to try with the 243 stem. The 6arc stem is obviously set up for the ELD's to contact behind the hollow cavity.
All of my brass is cleaned in ultrasonic and run through the RCBS trim mate prep center to clean primer holes and cut chamfer inside and out on the necks prior to loading.
I don't have any ELD's to try with the 243 stem. The 6arc stem is obviously set up for the ELD's to contact behind the hollow cavity.
All of my brass is cleaned in ultrasonic and run through the RCBS trim mate prep center to clean primer holes and cut chamfer inside and out on the necks prior to loading.