02-28-2024, 03:32 PM
I HAD a RARR Pmag variety in 300BO. The concept was good, but execution was poor. It didn't feed unless the bottom rear of the magazine was pushed forward, bolt lift was heavy, and the ejector would toss brass into the hinterlands. The bolt shroud is PLASTIC.
I've seen the Gen 2 with fluted barrel (not needed) and modular comb stock. I liked the old stock better.
I traded that RARR for the 110T. Its heavier, but has the aluminum bedding block in the stock, a magazine that feeds, easier bolt lift, and doesn't toss the brass nearly as far. I need to change that stupid bolt handle, but can fix it with a hacksaw and grinder.
I've seen the Gen 2 with fluted barrel (not needed) and modular comb stock. I liked the old stock better.
I traded that RARR for the 110T. Its heavier, but has the aluminum bedding block in the stock, a magazine that feeds, easier bolt lift, and doesn't toss the brass nearly as far. I need to change that stupid bolt handle, but can fix it with a hacksaw and grinder.