09-05-2020, 03:23 PM
(This post was last modified: 09-05-2020, 03:26 PM by GrendelHunter.)
Ok pulled all the rounds apart
Resied all 50 with 1/4 turn (with decaping pin removed)
Checked case overall length and chamber fit trimmed case length to 1.491 ish
I then lowered the previous powder charge from 28.3 thrown to 26.2 thrown
Using your sharpie trick seated bullets to 2.180 to be just off lands .010 thou ish
Rechecked chamber fit, all chamber and extract (some extract stiff (suspect neck thickness))
So I'm wondering if I must cut the necks down to safely shoot them or can I fire form, resize, and recheck thickness??
Big shout out to Lemonade and Trashy for the help.
THANK YOU FOR THE SHARPIE SHORTCUT AND THE HEADSPACE NUMBERS!!! HELL YA.
Resied all 50 with 1/4 turn (with decaping pin removed)
Checked case overall length and chamber fit trimmed case length to 1.491 ish
I then lowered the previous powder charge from 28.3 thrown to 26.2 thrown
Using your sharpie trick seated bullets to 2.180 to be just off lands .010 thou ish
Rechecked chamber fit, all chamber and extract (some extract stiff (suspect neck thickness))
So I'm wondering if I must cut the necks down to safely shoot them or can I fire form, resize, and recheck thickness??
Big shout out to Lemonade and Trashy for the help.
THANK YOU FOR THE SHARPIE SHORTCUT AND THE HEADSPACE NUMBERS!!! HELL YA.