Powder work-ups
#7
(10-20-2024, 08:34 AM)grayfox Wrote: No worries, this model also shows powder pressure at exit, I have a 107 smk bolt load with Lever, and if extrapolated out to 28" it does still show pressure at 7500 psi give or take, so the gas is still expanding... was not trying to knock the length at all.
I have the smk's b/c of my 6 Creed, so thought it would be nice to try in the Arc.

All is good, I enjoy the conversation. For me the ARC is a poor mans 6BR. Especially since we are only shooting out to 300yds. This is one of the many proprietary targets we shoot. This is a 100yd Cold Bore Target. First 2 shots must be taken at the top left sub-target. The circle in just under 1".

   
Reply


Messages In This Thread
Powder work-ups - by KMW1954 - 10-19-2024, 12:31 PM
RE: Powder work-ups - by Rickhem - 10-19-2024, 02:16 PM
RE: Powder work-ups - by KMW1954 - 10-19-2024, 08:30 PM
RE: Powder work-ups - by grayfox - 10-19-2024, 11:39 PM
RE: Powder work-ups - by KMW1954 - 10-20-2024, 12:12 AM
RE: Powder work-ups - by grayfox - 10-20-2024, 08:34 AM
RE: Powder work-ups - by KMW1954 - 10-20-2024, 02:32 PM
RE: Powder work-ups - by grayfox - 10-20-2024, 03:02 PM
RE: Powder work-ups - by KMW1954 - 10-20-2024, 08:00 PM
RE: Powder work-ups - by grayfox - 10-20-2024, 09:52 PM
RE: Powder work-ups - by BD1 - 10-22-2024, 02:26 PM
RE: Powder work-ups - by KMW1954 - 10-26-2024, 04:27 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)