With the Lever today I had 29.5-30.1 loads, the 29.9 was 2776 SD-5.6 but the group was pretty open (~1.5); the 30.1 group was 2798 SD-19 but was tight... one weird round, previous eject must have twirled and stayed at the top of the mag b/c the next one fed cock-eyed, didn't go into battery... dinged the case sidewall something Fierce and scraped the brass/bullet. Anyway I went to put it aside but loaded it (by mistake) anyway... bingo! 2804 ft/s!! fire-formed right back into shape. I'm still going to pull that case anyway.
If the one wacky MV (2770) was some kind of measurement fluke then my 2800 is a lot tighter than SD 19... the group (all were 4-round groups) went 0.86" b/c of one flyer, the other 3 were on top of each other...
I'm going to try these loads again.
There is also a lower node around 2737... which means I still have a 200-225 yd cartridge if I wanted to stay there. 2737 was about 0.9" for 4.
Nice thing for me with the 95 nosler's is they have a better BC than the Sst, and I have a few boxes... they seem to run about the same load/MV as the SSt's but I haven't graphed them yet.
If the one wacky MV (2770) was some kind of measurement fluke then my 2800 is a lot tighter than SD 19... the group (all were 4-round groups) went 0.86" b/c of one flyer, the other 3 were on top of each other...
I'm going to try these loads again.
There is also a lower node around 2737... which means I still have a 200-225 yd cartridge if I wanted to stay there. 2737 was about 0.9" for 4.
Nice thing for me with the 95 nosler's is they have a better BC than the Sst, and I have a few boxes... they seem to run about the same load/MV as the SSt's but I haven't graphed them yet.