Posts: 230
Threads: 51
Joined: Sep 2020
04-13-2022, 02:46 AM
(This post was last modified: 04-13-2022, 02:47 AM by alwie.)
All,
I have just started annealing my brass each time I reload. If you anneal in the reloading process when do you do it? Do you anneal before resizing or after resizing?
Alwie
Posts: 73
Threads: 12
Joined: Oct 2020
Deprime, then ultrasonic clean, then anneal, then size and trim to length
Posts: 181
Threads: 18
Joined: Sep 2021
....Annealing should always be done before resizing. This eliminates spring back, and ensures repeatable and accurate shoulder bumping and neck sizing.
Posts: 230
Threads: 51
Joined: Sep 2020
04-14-2022, 04:04 PM
(This post was last modified: 04-14-2022, 04:04 PM by alwie.)
(04-13-2022, 10:00 AM)r.tenorio671 Wrote: ....Annealing should always be done before resizing. This eliminates spring back, and ensures repeatable and accurate shoulder bumping and neck sizing.
In my mind if the base to shoulder distance is < max, then everything should chamber correctly. The question I have is …. Is bullet neck tension more important or less important than shoulder bump? If it is more important, then maybe I annealing after resizing and just before bullet seating.
Posts: 73
Threads: 12
Joined: Oct 2020
if you anneal after sizing you get inconsistent neck tension and its usually higher, ask me why I know that lol ......
Posts: 71
Threads: 19
Joined: Aug 2021
04-15-2022, 12:59 PM
(This post was last modified: 04-15-2022, 01:01 PM by gorillamotors.)
(04-15-2022, 01:48 AM)Bill Wrote: if you anneal after sizing you get inconsistent neck tension and its usually higher, ask me why I know that lol ......
Totally agree.
I also totally agree with your procedure above in that order but I use SS pins to clean. Same procedure just different method of cleaning.
"Life is tough, but it's tougher when you're stupid". Sgt Stryker
Posts: 181
Threads: 18
Joined: Sep 2021
(04-14-2022, 04:04 PM)alwie Wrote: (04-13-2022, 10:00 AM)r.tenorio671 Wrote: ....Annealing should always be done before resizing. This eliminates spring back, and ensures repeatable and accurate shoulder bumping and neck sizing.
In my mind if the base to shoulder distance is < max, then everything should chamber correctly. The question I have is …. Is bullet neck tension more important or less important than shoulder bump? If it is more important, then maybe I annealing after resizing and just before bullet seating.
....neck tension affects bullet release (and where in pressure curve it does so), whereas incorrect shoulder bump could prevent chambering (and firing).