05-12-2021, 10:10 AM
(This post was last modified: 05-12-2021, 10:12 AM by Thelaststraw.)
It's not too difficult in all honesty...I mean if one can grsp handloading rifle cartridges, then it's just another process to add. It also depends on your expectations of the brass and your ammo. For example, target and can blasting, hunting, precision/long range. Same with durability or longevity( how many uses of the brass)
You might get away with just sizing and run it, sometimes, depending on your rifle system. Same with annealing, may or may not be necessary....for you. I'm no expert on this but I have learned a lot here and at the grendel forum(same bunch for the most part).
I'm sure someone more experienced can be of more help and there is a thread on here about that very subject a few pages back. It's not difficult , but can be as complex as you require.
You might get away with just sizing and run it, sometimes, depending on your rifle system. Same with annealing, may or may not be necessary....for you. I'm no expert on this but I have learned a lot here and at the grendel forum(same bunch for the most part).
I'm sure someone more experienced can be of more help and there is a thread on here about that very subject a few pages back. It's not difficult , but can be as complex as you require.